青海附近想过夜电话联系

Welcome to Shandong Rugong Machinery Manufacturing Co., Ltd!

Add to collection | Website map

 Shandong Rugong Machinery Manufacturing Co., Ltd

National hotline:

400-996-7888

Current location: Home page >> news information

What problems should be paid attention to when using the heater in Greenhouse in winter

Author: Shandong Rugong Machinery Manufacturing Co., Ltd     Release time: August 20, 2020

The heater is actually a kind of equipment that can send out warm air. Its function is the same as the heater, but the heater is mainly used in the family, and the heater is mainly used in various types of workshops and large buildings. Its working efficiency is different from that of the heater. Its heating effect is very strong, and its air supply range is very wide So it's also bigger than a heater.

Introduction to the overall appearance of the heater in Greenhouse:

1. The stainless steel screw of the whole machine is durable.

2. Both cold and warm, cool in summer and warm in winter.

3. The outer rotor motor has high protection level, long service life, large air volume and low noise, and all blades are processed by dynamic balance.

4. Double layer antirust by hot galvanizing and electrostatic spraying on the shell, with stronger corrosion resistance.

5. Waterproof rubber cap can prevent the drill tail wire from rusting and is convenient for maintenance and repair.

6. The rear protective net is installed to avoid unnecessary damage to the heat dissipation core during transportation and use.

7. Aluminum alloy frame structure, more beautiful, firmer, lower machine noise, longer fan range.

8. The handle design on both sides of the machine makes it more convenient to carry and install.

9. All aluminum alloy blinds are easy to adjust the wind direction. When the machine is closed, it can be completely closed to prevent dust and foreign matters from flowing back into the heat dissipation core.

10. The rubber leg at the bottom is designed to prevent shock and prevent the bottom from directly contacting with the wet ground and causing rust risk.

11. Standard copper tube, supporting identification.

12. Cross arrangement of fans.

13. The "s" type drainage technology makes use of thermal efficiency.

14. The window fin increases the heat exchange time between air and aluminum fin, and the thermal efficiency increases by 15%.

15. Hot dip galvanized water chamber, no rust, no blockage of pipe.

16. The drainage outlet is set below, so that the water can be pumped out when the machine is not in use in winter to prevent the cooling pipe from freezing and cracking.


Recommended products
  • 30kW electric heater
  • 9kw factory electric heater
  • 70kw factory heater (oil fired heater)
  • 5kW electric hot air blower
contact us

Hotline: 400-996-7888

Address: No.6 Hongguang Road, Jining high tech Zone, Shandong Province